#Drives all listed as lsi megasr drivers
Is there logic in Acronis to include additional drivers from the PC where it is created? In this case, we did create it on the target PC, but it still doesn't work. :megasr: RAID5 support SAS drive supportīonus question: We have seen in the past that bootable media created on a different PC might not work, and that bootable media should always be created on the target PC. :megasr: Device: NCQ: Queue Depth: capacity=0x0 :megaswr: polling for interrupt status timed out for port=5, slot=0
:megasr: Setting the udma mode for atapi device to 4 :megasr: Device: NCQ: Queue Depth: capacity=0xe8e088b0 :megasr: HBA capabilities, S64A: SNCQ: SSNTF: SSS: ISS: SPM: SSC: PSC: NCS: CCCS: EMS: NP: Megasr 0000:00:1f.2: setting latency timer to 64 Otherwise, select up to eight SAS+SATA drives listed in Table 11.
#Drives all listed as lsi megasr update
Once the download is complete, double-click the installation file and follow the instructions provided in order to update your drivers. LSI Logic Embedded MegaRAID Device Driver Version (Date): 13. Lsi hba over to older firmware, receiving a driver. :LSI MegaSR RAID5 version v.2012, built on at 09:23:28 If you have not selected an onboard RAID upgrade option (ROM5 or ROM55), a mezzanine card, or a PCIe RAID controller for internal drives (LSI MegaRAID 9271-8i or 9271CV-8i), you may select up to 4 SATA-only drives, which will be controlled with the embedded SATA-only RAID controller. The LSI provider supports LSI MegaRAID, LSI SAS IR, LSI SAS IR2 and MegaSR controllers. Seems to me that the hard drives are recognized, but they don't show up as a source or destination for recovery or backup on the bootable media. The hard drives are recognized in Windows, but when we try to test our disaster recovery procedure using bootable media, we are not able to see any hard drives.
We have three hard drives installed, where two of them are RAID1. We have installed Acronis Backup for servers on a PC with LSI MegaSR RAID5.
0 kommentar(er)
